add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Transmission
Chassis
Wheels and tires
General information on wheels and tires
Technical conditions for the conversion of wheels and tires
Indexes of speed of tires
Markings on the disk
Composite wheels
Depreciation and divergence tires
Wear high-speed tires
Tyre service
Evenly worn tires
Measure the tread depth
One-sided wear
Diagonal uneven wear
Tire rolling noise
Balancing
Radial and lateral palpation of wheels and tires
Check of radial and lateral palpation of a disk with the tire by using a dial gauge for tires VAG 1435
Minimization
Lateral withdrawal of the car
Eliminating slip
Damage to tires
The design of the radial tire
Loss of air pressure in the tires
Damages of tires because of errors at mounting (assembly damages)
Marking the tire sidewall
Shift of wheels
Touareg 2003 model year
Repair of control system of air pressure in the tires
Removing and installing control unit, tire pressure monitoring J502
Repair of control system clearance
The components of the control system and clearance fitting locations
Removal and installation of the compressor unit without solenoid valve
Repair air line
Front suspension
Rear suspension
Tables
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

The components of the control system and clearance fitting locations



NOTE
For model year 2004 control unit regulation clearance 7L6 907 553 A / B (200 Hz) was replaced by a system control unit regulation clearance 7L0 907 553 F / * (800 Hz).

The components of the control system and clearance fitting locations
Fig. 4.39. The components of the control system of clearance and where they are: 1 - compressor unit solenoid valves; 2 - right rear pneumatic resilient element; 3 - Rear right level sensor body; 4 - the block of management control clearance; 5 - rear body acceleration sensor; 6 - Rear left level sensor body; 7 - Rear accumulator; 8 - Pneumatic elastic element back left; 9 - Front accumulator; 10 - Front left level sensor body; 11 - acceleration sensor front left wheel; 12 - Pneumatic elastic element front left; 13 - Body acceleration sensor front left; 14 - Body acceleration sensor, front right; 15 - Wheel acceleration sensor, front right; 16 - Pneumatic elastic element front right; 17 - front right level sensor body



By using the new control unit eliminated the need for wheel acceleration sensors and level sensors are adapted stand.
If, instead of the control unit (200 Hz) is set to block (800 Hz), you must also replace the level sensor body. Acceleration sensors wheels remain on the vehicle for the "sealing" of the pipeline.




« previos page
Repair of control system clearance
next page »
Removal and installation of the compressor unit without solenoid valve

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.