Adjusting the position and the door lock striker

The following general requirements for adjusting the position of the door:

- The door must be opened and closed easily;

- The edge of the door should be flush with the external elements of the vehicle;

- All the doors are regulated at the striker and hinges.

Adjusting the position of the front door as follows:

- Loosen both screws on the side of the door;

- Adjust the position of the front door (max. 1 mm);

- Tighten the screws.

Bolts door hinges on the body (Fig. 11.54) allow for adjustment in a broader range. Such an adjustment is made as follows:

- Remove the liner from the wing;

- Remove the foam seal;

- Unscrew the screws in the back of the inside wheel arch;

- Adjust the position of the front door;

- Tighten the screws in the back of the inside of the wheel arches (Tightening torque 21 Nm).

Adjusting the position of the rear door (Fig. 11.55) is as follows:

- Loosen the four screws in the stand and adjust the position of the door;

- The rear doors on both sides and can be adjusted at the hinge;

- Tighten the bolts to 21 Nm.

Adjustment of striker (Fig. 11.56) as follows:

- Loosen the screws so that the latch lock can be moved;

- The door should not rely on the lock latch and lock striker must not pressing up the door;

- Hold the handle drawn, make sure that the door opens and closes with no extraneous noise;

- Check the closing of the door and make sure it closes flush with the body;

- Tighten the bolts to 21 Nm.