add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Design Features
Removing and installing driver's airbag
Replacing the front seat belt
Replacement of a back seat belt
Removal and installation of the electronic control unit an additional system of passive safety
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Replacing the front seat belt



NOTE
Replacing the front seat belts is shown by the example of the driver seat belt. Safety belt front passenger replaced similarly.

You will need: key TORX T30, ?�17?�, Phillips screwdriver blade.
1. If seat belts are equipped with pretensioners, disconnect a wire from the plug "minus" of the storage battery.

WARNINGS
After disconnecting the wires from the plug "minus" battery, you must wait at least 10 minutes, and only after that we can proceed to withdraw the seat belt pretensioner equipped.
Dismantling pretensioners prohibited.
Do not drop the reel seat belts with pretensioners and ingress of water and oil.
Do not expose the seat belt temperature above 95 ?� C.

2. Remove the bottom of the B-pillar trim (see. "Removal and installation of facing of salon").

NOTE
The driver's seat is removed for clarity.

3. Remove the two screws securing the belt guide for the central rack.
4. Remove the decorative cap from the lower bolts of the belt ...
5. ... and remove the bolt.

A WARNING
In the seat belt anchor bolt installed washers and spacers, do not lose them.

6. Fold trim buckle ...
7. ... and turn out a bolt of the top fastening of the belt.
8. Remove the screw securing inertia reel ...
9. ... and remove the spool from the pillar.
10. Before removing the front seat belt buckle, disconnect the harness connector warning light Seat belt (if you remove the driver's seat belt).
11. Remove the bolt fastening the seat belt buckle to the seat ...
12. ... and remove the lock.
13. Install the front seat belt in the reverse order of removal.




« previos page
Removing and installing driver's airbag
next page »
Replacement of a back seat belt

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.