 printable version
The switch of a cleaner and a windscreen washer
The switch may be installed in the following three points:
1 - intermittent movement of brushes;
2 - slow movement of the brush;
3 - rapid movement of the brush.
| The provisions of the windshield wiper switch |
A warning  To prevent damage to the wiper system, do not attempt to clean the heavy precipitation in the form of snow or ice and accumulated snow or ice must be cleaned manually. If there is only a small layer of snow or ice, turn on the heater in the heating mode of the windscreen and melt snow or ice before using the wipers.
Job Windshield Washer
Washer fluid is applied to the windshield when the lever switch wiper / washer towards the steering wheel. If the vehicle is equipped with intermittent wiper operation, when you turn on the windshield washer, simultaneously with the cleaning liquid wipers automatically will make two turns at a time, like a switch wiper / windshield washer is released.
| The direction of movement of the windshield wiper switch to turn on the washer |
If the vehicle is not equipped with intermittent wiper operation, then when the windscreen washer will be made only supply the washing liquid until the switch wiper / windshield washer is pressed.
A warning Do not include flushing more than 15 seconds, or when there is no washer fluid reservoir.
In cold weather, before using the wiper, make sure the wiper blades are not frozen to the glass.
In areas where water freezes in winter, to clean the windshield, use antifreeze liquid detergent.
Demisting the windscreen
To remove deposited on the windshield of fog move lever switch wiper / windshield washer upward. Wiper blades make one move.
| The direction of movement of the windshield wiper switch to the windscreen demisting |
Wiper with variable interval mode wiper
To use the mode of operation of the wiper blades with a variable interval, move the wiper switch to the position "INT" (Intermittent). In this position, the switch interval intermittent operation of the wiper blades can be changed in 5 positions by turning the adjusting wheel interval intermittent switch on the lever.
| The direction of rotation of the adjustment wheel at the interval intermittent lever switch |
|
