REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Bleeding the hydraulic system of a drive of brakes with scanner use

Any hydraulic system works normally if air is removed from it.

PERFORMANCE ORDER

	1. Remove the cap from the expansion tank with brake fluid. Recommended brake fluid: DOT3
A warning The brake liquid dissolves a paint, plastic and wire insulation, so if you accidentally hit fluid on the paintwork of the car or its components wash with plenty of water. When pumping pressure does not depress the brake pedal
	2. Remove the cap from the bleeder, and attach it to one end of the transparent hose and the other end of the hose, insert the glass container of sufficient volume, half-filled with brake fluid.
	3. Connect the scanner to the diagnostic connector located under the dashboard.
4. In accordance with the instructions for operating the scanner, select the appropriate option.
	A warning Consider the maximum working time of ABS works with the scanner to prevent burnout of the motor pump. 1) Set the auto manufacturers.
	2) Set the name of the car. 3) Set the test anti-lock brake system 4) Establish a method for removing the air. 5) Press "YES" to enable the pump to the motor and solenoid valve.
	6) Wait for 60 seconds before the operation of removal of air, since, otherwise, can damage the motor.
5. Slowly depress the brake pedal several times. While pressing the brake pedal wrench to loosen the bleeder valve and wait until the brake fluid flows out without air bubbles. Tighten the bleeder valve and release the brake pedal.
6. Repeat step 5 to remove the air from the brake mechanisms of other wheels.
	7. Tighten the bleeder valve. Tightening torque: 7-9 N ??? m

« previos page
Anti-lock brakes (ABS)

next page »
Checking and adjusting the brake pedal position