REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Check the brake servo

PERFORMANCE ORDER

1. Start the engine and after 1-2 minutes, stop it. Press the brake pedal with ordinary effort. If the first pedal stroke is long and the second course is shorter than the first move - this indicates normal operation of the vacuum brake booster.
2. With the engine off, repeatedly press the brake pedal. Start the engine. If the brake pedal is moved down immediately after the engine starts, it indicates normal operation of the vacuum brake booster.
3. Start the engine. Press the brake pedal with ordinary effort. Stop the engine. Slowly press the brake pedal and hold it for 30 seconds. If the pedal height does not change, the vacuum brake booster is working properly. Otherwise, check up the unilateral vacuum valve or a vacuum hose for damage and check the reliability of their fastenings.