REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Brake pedal

1 - the switch of stoplights;
2 - bushings;

3 - an arm;
4 - spring;
5 - pedal

Withdrawal

PERFORMANCE ORDER

1. Remove the brake light switch.
2. Remove the flanged nuts (4EA) and bolt (1EA) fixing the brake pedal bracket.
3. Remove the cotter pin and remove the pin with a head and a hole for the pin.
	4. Remove the brake pedal.

Check

PERFORMANCE ORDER

1. Check the sleeve for wear.
2. Check the brake pedal to the absence of distortion.
3. Check the brake pedal return spring for damage.
	4. Check the brake light switch 1) An ohmmeter connected to the terminals of the brake light switch, check the conductivity. 2) When you plug the conductivity should be absent and appear when releasing the plunger.

Setting

PERFORMANCE ORDER

1. Installation is spent to sequences, return to removal.
A warning Be sure to install the cotter pin on the pin with a head and pull the pin hole of the brake pedal.
2. Install the brake pedal and secure the collar nut and bolt. Torque: 8-12 N ??? m
3. Check and, if necessary, adjust the height of installation of a pedal and brake pedal free wheeling.
	4. Install the brake light switch.