REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Replacing brake pads on the rear drum brakes

The brake pads on the rear drum brakes

1 - Front brake pad support;
2 - a brake board;
3 - working brake cylinder;
4 - heck lever;
5 - Spreader bracket;
6 - the parking brake lever;
7 - the upper return spring;

8 - Rear brake shoes;
9 - a spring;
10 - Clip;
11 - brake drum;
12 - the lower the return spring;
13 - a spring regulator;
14 - the front brake pads.

Withdrawal

PERFORMANCE ORDER

1. Remove the wheel and brake drum.
	2. Remove the support clamp brake pads, spring automatic regulator and lever knob.
3. Squeeze the pad and remove the pad controller.
	4. Remove the brake pads together with return springs.

Check

PERFORMANCE ORDER

1. Measure the inner diameter of the brake drum. Indicator of hour type check up palpation of a brake drum. Replace the brake drum if the inner diameter of the drum exceeds the limit. Maximum diameter: 200 mm The beating of the drum brake: 0.015 mm
	2. Measure the thickness of the rear brake pads. Replace all the brake pads on the same axle of a vehicle, even if only one block has a thickness less than the maximum allowable. Minimum thickness: 1.0 mm
3. Check the brake linings for contamination with oil or grease, deterioration and cracks.
4. Examine the wheel cylinders for leakage of brake fluid.
5. Inspect the brake shield for wear or damage.
	6. Check the fit of the uniformity of the brake pads against the brake drum.

Setting

PERFORMANCE ORDER

1. greasing grease the following points of contact pads: a. the point of contact with the brake pads brake board; b. contact point with the brake pad backing plate. Recommended lubricant: SAE J310, NLGI ?��2

2. Set the rack supporting the brake pad.
3. Install the return springs on the brake pads.
	4. After installing the brake drum several times tighten the parking brake lever.

« previos page
The main brake cylinder

next page »
Replacing the working brake cylinder