REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Replacing the working brake cylinder

PERFORMANCE ORDER

1. Remove the brake pads.
2. Disconnect the brake tube.
	3. Remove the screws and remove the working brake cylinder.
4. Remove the dust covers from the working brake cylinder.
5. Remove the piston.
	6. Remove the return spring.
7. Before assembling the working brake cylinder, check the condition of the following parts: - Cylinder and piston for wear, damage and corrosion; - The case of the working brake cylinder for damage and cracks; - The contact surface of the piston and the brake pads for wear.
8. The assembly is carried out in sequence, return dismantling.
	A warning Before assembly, clean the working brake cylinder with isopropyl alcohol. Before assembly, lubricate the brake fluid piston and cylinder. When assembling the need to use new cuffs and dust covers. Be careful not to lose the steel ball drain valve.