printable version

Removal and installation of a rope assembly handbrake

All the self-locking nuts and bolts must be replaced without fail!

Front cable

Details of installation of a pedal charging the parking brake

PERFORMANCE ORDER

Details of installation of the front section of the rope assembly handbrake shown in the illustration, which includes all the links in the text. Make preload controller slack (the compensation lever) drive cable. Disconnect the cable (85) from the intermediate lever (91) and using the tool (043) to release it from its holder on the floor panel. Remove the cover mounted to the left under the dashboard. Remove the carpet. When using the tool (043), disconnect the cable (85), parking brake pedal (75), - try not to drop a rubber ring (85c). Give a nut, loosen the cable cover into the sheath well. Remove retainer (85a) and push the cable through the grommet (85b) in the transmission tunnel. Installation is in the reverse order. In conclusion unload controller slack (the compensation lever) and make adjustment of the parking brake (see. Section Adjusting the parking brake).

Rear cable

Details of installation of the rear section of the rope assembly handbrake

PERFORMANCE ORDER

Details of installation of the rear section of the rope assembly handbrake shown in the illustration, which includes all the links in the text. Remove the parking brake shoes (see. Section Replacement of boots of a lay brake). Disconnect the cable (86) of the compensation lever (92). When using the tool (043) release the rope (86) of the clips on the floor panels. Release the rope (86) from the hub assembly. Installation is in the reverse order.