add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W163
Home
 
Mercedes-Benz
W163
Introduction
Controls and receptions of safe operation
Current care and maintenance
Engine
System of cooling, heating and air conditioner
The power supply system and exhaust
Systems of an electric motor
Manual box of a gear change
The transmission automatically processed
Transmission Line
Brakes and auxiliary systems
Suspension and steering
Body
Onboard electric
General information and precautions
Search of causes of failures of electrical equipment
Safety locks - the general information
Circuit breakers - the general information
Relay - the general information and check of serviceability of functioning
The digital CAN data bus
Mounting blocks, parts of control systems
The instrument panel, switches, trip computer
Drive motors
Signal and lights, rain sensors and outdoor temperature
System of additional safety (SRS)
Removal and installation of modules, front airbags
Removing and installing side airbag modules
Audio
Wiring
 


Hit Counter by Digits


print page printable version

System of additional safety (SRS)



Details of installation of the module driver's front airbag on models of release on 08.31.01

Details of installation of the module driver's front airbag on models of release since 1.9.01


PERFORMANCE ORDER

  1. Details of installation of the module driver's front airbag is shown in the illustrations, which include all the links in the text.
  2. Disconnect the negative wire from the battery.
  3. Remove the mounting screws (2).
  4. Separate the airbag module (1) from the steering wheel.
  5. On models of release since 1.9.01 release latches (3) on the pin wiring connector (4 and 5).
  6. Disconnect the connector (s) wiring (4/4 and 5) the gas generator igniter.
  7. Finally, remove the airbag module (1).

Recyclable module must first be discharged in the workshop Car!

  1. Installation is in the reverse order - track reliability of the latch clicks into place (s) connector (s).
  2. After finishing the installation, make sure of serviceability of operation of the combined return mechanism stalk in conclusion make a diagnosis SRS using special equipment (contact your service specialist).

Passenger Air Bag

Details of installation of the module front passenger airbags on models of release on 08.31.01

Details of installation of the module front passenger airbags on models of release on 08.31.01


PERFORMANCE ORDER

  1. Details of installation of the module of the passenger's front airbag is shown in the illustrations, which include all the links in the text.
  2. Disconnect the negative wire from the battery.
  3. Remove the instrument panel (1) (see chap. Body).
  4. On models of release since 1.9.01 release latches (3) on the pin wiring connector (4 and 5).
  5. Disconnect the connector (s) wiring (4/4 and 5) the gas generator igniter.
  6. Release self-locking nuts (2) and remove the module of the passenger's front airbag.

Recyclable module must first be discharged in the workshop Car!

  1. Installation is in the reverse order - track reliability of the latch clicks into place (s) connector (s).
  2. Finally, make a diagnosis of the SRS using special equipment (contact your service specialist).





« previos page
Removal and installation of a rain sensor (with appropriate equipment)
next page »
Removal and installation of modules, front airbags

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.