 printable version
Drive motors
Details of the installation of electric motors drive the group adjustment of the seat cushion
| - Corresponding illustrative material is presented in the figure, which includes all the links in the text.
- Remove the back of the front seat (see chap. Body).
- Remove the screws (2) on the frame.
- Remove the seat cushion (1) with the adjusting mechanism.
- Disconnect the electrical connectors of the drive motors (M25m2 and M25m3).
- Remove the screws (3) support arms (4 and 5) and remove the latter.
- Remove the retaining rings (6) and remove the bearing pins (7) of the fork head.
- Remove the screws (8) and remove the axle holders.
- Remove the electric motors drive the front height adjustment (M25m2) and rear (M25m3) the edges of the pillow.
- Installation is in the reverse order.
- Finally, check the serviceability of functioning of the electric drive.
|
|
Electric motors drive adjustment of the cushion Details of installation of electric drive group adjusting the inclination of the seat back
| - Corresponding illustrative material is presented in the figure, which includes all the links in the text.
- Remove the seatback (see chap. Body).
- Remove the back cover (2).
- Depressing the backrest frame (3) down, remove the plug-guide plates (1).
- Remove the lock washer (4) of the axis controller (7), - the puck must be replaced without fail.
- Give a nut (6) fixing the drive motor (M25m5).
- Remove the rubber damper (5).
- Remove the axle (7) of the regulator.
- Disconnect the connector (H54 / 20) and remove the drive motor assembly (M25m5) - Pull the cover (1) from the frame by approximately 10 cm.
- Installation is in the reverse order.
|
|
|
