REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B5 (from 1996 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B5
		Instructions
		Maintenance
		Engines
		Cooling
		Fuel system
		Motor Control
		An exhaust system
		Transmission
		Chassis
		Steering
		Brakes
		Body
		Heating, ventilation
		Electrical
			Incandescent lamps
			general information
			Electrical circuits
			Circuit breakers
			Terms battery care
			Checking the battery
			Accumulator charging
			Battery
			Charging System
			Generator
			Replacement of brushes of the generator and a pressure regulator
			The engine starting system
			Starter
			Pull the starter relay
			Replacement of bulbs of external illumination
			Replacement of bulbs of internal illumination
			Devices of external illumination
			The executive engine of the proof-reader of light of headlights
			Adjusting headlights
			Discharge lamps dipped beam
			Device combination
			Multipurpose switches of a steering column
			Switches
			Radio
			Tweeter
			Woofers
			Antenna
			Check the rear window defogger
			Windshield Wiper Motor
			Rear window wiper motor
			Windscreen washer pumps
			Central locking system
			The basic malfunctions of the generator
			The basic malfunctions of a starter
			Electrical circuits

printable version

Multipurpose switches of a steering column

Location of screws in the lower column cover

1 - the top casing of a steering column

Location of screws securing the bottom of the column cover

1 - a bolt,
2 - locking lever adjustable steering column,
3 - the bottom casing of a steering column

Withdrawal

PERFORMANCE ORDER

1. Turn off the ignition and remove a wire of weight from the accumulator.
2. Remove the air bag to the central part of the steering wheel.
3. Set the steering wheel to move straight ahead.
	4. Remove the central bolt (2) of the steering wheel (1) and remove the steering wheel.
5. Remove the two screws from the lower column cover, see. Fig. Arrangement of screws in the lower column cover.
6. Remove the top cover (1) of the steering column, see. Fig. Location of screws in the lower column cover.
7. Remove the four screws holding the bottom casing of a steering column, see. Fig. Arrangement of screws of fastening of the bottom casing of a steering column.
8. Using a hex wrench, unscrew the screw (1). See Fig. Arrangement of screws of fastening of the bottom casing of a steering column.
9. Remove the bottom casing of a steering column.
Loosen the bolt of the multifunction switch on the steering column.
10. Disconnect the multifunction switch electrical connectors. Keep in mind that the coil spring is on the multifunction steering column switch, so do not turn when removing the spring from the middle position.
11. Remove the multifunction switch.

Setting

Set multifunction switch

1 - the steering wheel,
2 - multifunction switch
3 - bolt switch

a = 3 mm

PERFORMANCE ORDER

1. Place the multi-function switch on the steering column, but at this stage to tighten the bolt of the multifunction switch.

2. Install the steering wheel.

3. Moving, set the multi-function switch (2) in such a position that the distance (a) between the steering wheel (1) and the multi-function switch is 3 mm. See Fig. Set the multifunction switch.

4. Remove the steering wheel and set the upper and lower casings of a steering column.

5. Install the steering wheel.

6. Install the air bag in the center of the steering wheel.

7. Connect the ground cable to the battery.

« previos page
Device combination

next page »
Switches