 printable version
Pull the starter relay
Place sealant application
| F - the connection of the traction relay and starter |
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the starter. | | 2. Using additional wires of large cross section, connect the starter to the negative battery terminal and the positive terminal of the battery connected to the terminal 50. If the starter drive gear is moved forward, but the starter motor does not rotate, so defective or burned starter motor or the contacts of the traction relay. | | 3. If the starter gear wheel does not move forward, then, it has failed the traction relay and must be replaced. | | 4. Loosen the nut and disconnect the cable from the starter motor to the bottom contact of the traction relay. | | 5. Remove the screws and remove the traction relay from a starter. |
|
Setting
| PERFORMANCE ORDER | | 1. Apply a thin coat of sealant to the surface of the traction relay interfaced with the starter. See Fig. Place sealant application. | | 2. Engage the anchor of the traction relay of the control lever, and then screw in the screws that secure the traction relay to the starter. | | 3. Connect the motor starter to the bottom contact of the traction relay and secure it. | | 4. Check the operation of the traction relay. | | 5. Install the starter. |
|
|
