Removal and installation frame

Withdrawal

Remove the cover.

Pull the latches on the left and right side out and pull the frame up (Fig. 3.16).

Setting

Installation is carried out in reverse order.

Install the patch.

Switching the selector in the absence of power from position ?�P?� - emergency release.

Click on the top of the magnet core by means of a long, thin screwdriver in the direction of the arrow (Fig. 3.17).

It is not necessary to remove the handle.

Removing and installing selector lever lock solenoid in position ?�P?� N380.

Withdrawal

Remove the drive gear.

Unlock and disconnect plug.

Unlock the solenoid in mounting and pull up the outside of the locking lever 1 and the drive gear (Fig. 3.18).

Setting

Put the lever of the electromagnet 2 vertically.

Install the solenoid at a slight angle to mount the drive gear.

Connect the lever 2 with a locking lever 1 (Fig. 3.18).

Slide the solenoid to lock the drive in gear until it locks in its bracket arrow.

Check that the solenoid is mounted in the fixture against the stop and the lever 2 is in engagement with the locking arm 1 (Fig. 3.19).