add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Overview
Example data plate car
Front brakes
Rear brakes
Check the brake system
Bleeding brake system
Bleeding (major)
Additional pumping
The sequence of pumping
Removal and installation of the membrane potentiometer stroke brake booster G420
Removal and installation of the vacuum pump the brakes V192
Removing and installing brake servo pressure sensor G294
Removal and installation of the main brake cylinder
Removing and installing brake booster
Repair the brake pipe
Repairing front brake, Brembo brake calipers 17 '' (1LC)
Removing and installing brake pads
Repair rear wheel brakes, brake caliper FN 44
Removing and installing brake pads
Adjusting the parking brake
Adjust the brake pads on two wheels
Checking freewheel lever parking brake pedal
Removal and installation of the lever of the foot parking brake
Removing and installing rear brake cables
Disconnecting the brake pedal from the brake booster
Connecting the brake pedal to the brake booster
Removal, installation and adjustment of brake light switch
Anti-lock braking system (ABS)
Tables
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of the main brake cylinder



Withdrawal
Remove the liner plenum chamber.
Remove the seal of the engine compartment and the bar in the brake booster.
Remove the wall with a plenum chamber.
Put in a plenum chamber in the master cylinder enough of lint rags.
Evacuate the maximum possible amount of brake fluid using a device for filling and leveling devices VAS 5234 or for pumping liquid VAG 1869/4 of the brake fluid reservoir.
Remove the plug from the sensor warning indicator float.
Remove the plug from the pressure sensor in the brake system.
On vehicles with a manual gearbox, remove clutch master cylinder hose and close the flap.
Remove the brake fluid reservoir. To do this, press the latches on the outside and at the same time remove the tank from the tank cap.
Remove the front left brake pipe from the holder on the master cylinder.
Remove the brake pipes from the master cylinder, close the brake pipes using plugs 1H0 698 311 A from the repair kit.
Unscrew the nuts on the master cylinder.
Carefully remove the brake master cylinder to the brake booster.

Setting
Installation is carried out in reverse order.
When installing pay attention to the following points.
When assembling the brake master cylinder and brake booster follow proper landing push rod in the brake master cylinder.
Does the O-ring between the master cylinder and brake booster.
Bleed the brake system.
After pumping the brake system must perform basic configuration of the pressure sensor in the brake system G201.
VAS 5051 and select the function connect




« previos page
Removing and installing brake servo pressure sensor G294
next page »
Removing and installing brake booster

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.