| 1. Disconnect from the valve of cold start. |
| 2. Remove the fuel injection valves. |
| 3. Disconnect supply and return lines to the fuel distributor. |
| 4. Send the output from the valve into suitable containers. |
A warning  Protect your eyes from splashes of fuel.
|
| 5. Disconnect the blue plug (arrow) temperature sensor coolant pipe. |
| 6. Connect the contacts of the plug temperature sensor resistance of 15 ohms. |
 | 7. The tip of fuel injection valve (2) via additional wires connected to the contacts (1) the fuel distributor. |
| 8. Switch on the starter for a few seconds (assistant), comparing with the jet injection valves form each other. The jet fuel must have a tapered shape, and all valves look the same. |
| 9. Install the valve. |
A warning The use of household cleaning products is not allowed. To prevent damage to the washer pump.
|
| 10. When attaching the valve to note that the rings will be damaged. Check O-ring for damage and replace if necessary. Before installation, lubricate the O-ring with fuel. |
