add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Kia Rio
Home
 
Kia
Rio
Instructions
Engines A3E, A5D
Greasing system
Cooling
Fuel system
Ignition system
Coupling
Transmission
Manual Transmission
Automatic transmission F4E-K
Technical data
Check of work and adjustment of position of the selector lever
Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
Testing time delay (Lag test)
Check the transmission fluid pressure
Check of level and liquid replacement in an automatic transmission
The procedure for replacing the liquid in the converter of an automatic transmission
Leaks of a liquid from an automatic transmission
Replacement of oil sealing rings
Removing and installing automatic transmission
Repair of an automatic transmission
Radiator cooling automatic transmission fluid
Valve block
The case of regulating valves
Oil pump
Check the resistance of the sensor, input speed of the turbine wheel
Check resistance of speed sensor
Mode switch transmission OD
Switch range gearbox
The temperature sensor of an automatic transmission
Solenoid valves
The linear solenoid valve
Lever
Repair of the selector lever
Check the mechanism selector lever lock
Axes and power shafts
Suspension
Wheels and tires
Steering
Brakes
Body
The air conditioning system
Electrical equipment
 


Hit Counter by Digits


print page printable version

Mode switch transmission OD



Check

PERFORMANCE ORDER
1. Turn on the ignition.
2. Make sure that the O / D OFF is not illuminated. Press the switch.
3. If it is not working properly, continue checking.

Check voltage

PERFORMANCE ORDER
1. Remove the central console.
2. Turn on the ignition.
3. Measure the voltage at the terminals of the connector switch O / D.

Switch position
Contact socket
Normal,
1
4
Presses,
AT
0
B: Battery voltage
0
0
4. If the voltage at the terminals of the connector switch is not correct, provorte conductivity in switch O / D

Check conduction

PERFORMANCE ORDER
1. Disconnect the negative battery terminal.
2. Disconnect the connector from the switch O / D.
3. Check the conductivity of the switch O / D terminal pin H-05.
Switch position
Contact socket
1
4
Average
open
Pressing
closed
4. Otherwise, replace the gear lever knob.
5. If the switch is operating normally, check the electrical circuit that goes to the gearbox control unit.
6. Connect the switch O / D.
7. Install the center console.
8. Attach the wire to the negative terminal of the battery.




« previos page
Check resistance of speed sensor		 next page »
Switch range gearbox

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.