REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
		System of cooling, heating and air conditioner
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
			Clutch
			Drive shafts
			Drive shafts
			The transfer case and differentials
				Removing and installing transfer case control module
				Removing and installing transfer case
				Replacing the oil seal input shaft transfer case
				Replacing the gland outlet flange rear propeller shaft
				Replacing the front output shaft oil seal
				Removal and installation of the servo switch between transfer case
				Removing and installing chain drive transfer case
				Removing and installing front output shaft of the transfer case
				Removal and installation of assemblage of planetary gear center differential transfer case
				Removal and installation of assemblage of the bearing assembly of the transfer case
				Removing and installing oil pump transfer case
				Removal and installation of the switching mechanism of the transfer case
				Removing and installing gear reduction transfer case
				Replacing the side seals differentials
				Replacement seals top gear differentials
				Removing and installing differentials
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric

printable version

Removal and installation of assemblage of the bearing assembly of the transfer case

Details of installation of bearing assembly transfer case

1 - Retaining Ring
2 - Bearing assembly
Arrow - Direction of rotation during removal of the locking ring

PERFORMANCE ORDER
Details of installation of bearing assembly the transfer case shown in the illustration, which includes all the links in the text.
Remove the planetary gear assembly (see. Section Removal and installation of assemblage of planetary gear center differential distributing box).
Turning in the direction of the arrow, remove the retaining ring (1).
Pull up and remove the bearing assembly with a holder (2).
Rinse all components, suede and wipe dry with compressed air.
Installation is in the reverse order.
Finally, check the transfer case for signs of leaks.

« previos page
Removal and installation of assemblage of planetary gear center differential transfer case

next page »
Removing and installing oil pump transfer case