REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
			Specifications
			Outdoor equipment and body parts
			Salon Equipment
				Removal and installation of the lower lids dashboard
				Removal and installation of the instrument panel vents ducts
				Removal and installation of the glove compartment
				Removing and installing handle dashboard
				Removing and installing front ashtray
				Refitting the lower left section of the instrument panel trim
				Removal and installation of the knee fully
				Removal and installation of the end cap of the steering column
				Removal and installation of wall panel sections of the dashboard console
				Removing and installing center console
				Removal and installation of the instrument cluster
				Removal and installation of the instrument panel
				Removal and installation of salon mirrors
				Removing and installing panels finish touring racks
				Removing and installing trim panels
				Removal and installation of ceiling upholstery (Universal model)
				Removing and installing panels carpeting
				Removing and installing front seat assemblies
				Removing and installing rear seat assemblies
				Removal and installation of seat backs
				Removal and installation of seat cushions
		Onboard electric
		Wiring

Removal and installation of salon mirrors

Installation Details of salon mirrors


1 - Connector wiring 2 - Stand 3 - Wiring the sensor	4 - Sampling 5 - Mirror

PERFORMANCE ORDER

Remove the roof console switches (see chap. Onboard electric equipment).
Overcoming the resistance of the springs in the bed (2), press down one side of the mirror assembly (5), permanently separate assembly and disunite a socket (1) wiring.
Installation is in the reverse order - track correctness of electrical contact (3) of the sensor in the sample (4).
Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor).