 printable version
Removing and installing trim panels
Convertible models Panels finishing side windows Details panel installation side window trim Cabriolet models
| - Open the convertible top.
- Remove side window (see. Section Removal and installation of the glazing of the body).
- Remove the screws (2) and remove the retaining loop (1).
- Remove the screws (4) and remove the prop vetrootboynika (3).
- Remove the protector (5).
- Release the two latches (7) and remove the finishing panel (6).
- Installation is in the reverse order.
|
|
Side panel Details of installation of the side panels trim Cabriolet models (1 of 3)
Details of installation of the side panels trim Cabriolet models (2 of 3) Details of installation of the side panels trim Cabriolet models (3 of 3)  | | |
| - Remove the trim panel side of the window (see. Above).
- Remove the protector (1) in the area of the rack B.
- Release three retainer (4) and separate the bottom side finishing panel (2) from the top (3).
- Remove the covering plates and remove the bolt (A) of the lower anchors (B) belt.
- Release the clip (4) and fed up, remove the lower side finishing panel (2).
- Remove the rivet (5).
- Remove the luggage compartment lid with vetrootboynikom.
- Give a nut (6) convertible.
- Remove the decorative trim and remove the screws (8) with the aim of weakening the frame (7) on the window shelf.
- Remove the support (9) vetrootboynika (three on each side).
- Disconnect the electrical wiring from the luggage compartment light (E18 / E18 2 or / 3).
- Release the clips (arrows) and release the top finishing panel (3).
- On models corresponding complete set (code E08), disconnect the wiring from the speaker.
- On models corresponding complete set (code H11), disconnect the wiring harness for heated rear seats.
- Fed up, remove the cover (3).
- Installation is in the reverse order.
|
|
Touring Models Side panel Details of installation of the side panels trim models Universal
| - Separate from the trim panel (2) Protector (1).
- Remove the finishing panel (2) (see. Section Removal and installation of the panels finish touring racks), - do not forget to disunite the speaker wiring connector.
- Release the rubber seal (3) in the area of installation of the side paneling (4).
- Unscrew the bolts anchoring sites (7 and 8) of a seat belt.
- Remove the side finishing panel (4).
- Installation is in the reverse order - track correctness of landing of the lower edge of the panel (arrow).
|
|
Upper back panel Details of installation of the upper rear panel trim models Universal
| - Remove trim panels for rear roof pillar (3) (see. Section Removal and installation of the panels finish touring racks).
- Remove the rear cabin lights (see chap. Onboard electric equipment).
- On models corresponding complete set (code SD0) turn out beneath the decorative cover (6) and remove the top screw eye fixing child seat ISOFIX.
- Remove the screws (5) and remove the rear upper finishing panel (4), carefully removing it from the guide supports a ceiling upholstery.
- Installation is in the reverse order.
- Finally, make sure of serviceability of functioning and cabin lamps (with appropriate equipment) signaling device BA.
|
|
| 
