 printable version
Removal and installation of the instrument cluster
Model release of 11.30.00 Details of installation of a combination of devices (model of release of 11/30/00)
| - Disconnect the negative wire from the battery.
- Skip the shooting hook into the gap between the dashboard and the combination of (A1), - try not to damage the plastic.
- Release and disunite wiring connectors (1 and 2).
- Release combination (A1) from the panel.
- Installation is in the reverse order.
|
|
Models of release since 01.12.00 Details of installation of a combination of devices (model of release from 01.12.00)  | | |
| - On models corresponding complete set (code ET2) activate the service mode of the emergency call TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE).
- Turn the adjustable steering column all the way down until it stops and pull the steering wheel.
| Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last.
|  | - Hooking a suitable wedge, release the four clamps and remove the covering plates (1).
- Skip shooting hooks in the instrument cluster (A1), expand their curved ends outward until it stops, push in and fix in the guide, gently squeeze out.
- Expand the hook down through 90 ?� and pull, release the combination of (A1) of the instrument panel.
- Disconnect the connector (2) and completely remove a combination of devices (1).
- Installation is in the reverse order - with the appropriate configuration (code ET2) deactivate service mode of TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE).
- Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor).
|
|
|
