| 1. Screw the threaded oil drain plug with a new sealing ring and tighten securely, but not too much. The tightening torque at the 4-cylinder engine: 30 Nm; 5 in-cylinder 50 Nm. |
| 2. Clean the oil filter flange on the cylinder block fuel, Remove any remnants of oil filter gasket. |
| 3. Coat a thin layer of oil rubber sealing ring of the oil filter. |
| 4. The new filter is tightened only by hand. Once the filter gasket touches the cylinder rotate the filter an additional 1/2 turn. Pay attention to the instructions on the oil filter. |
 | 5. Pour the new oil through the oil filler neck (arrow) on the cylinder head cover. Then, check the oil level gauge oil. |
A warning  It is strongly recommended to drink half a liter of oil on smaller and warm up the engine. Stop the engine and after a few minutes check the oil level indicator. If necessary, top up. Excess oil is necessary to suck, otherwise it will damage the catalyst.
|
| 6. After leaving the control check the tightness of a threaded plug oil drain plug and oil filter, if necessary, gently pull up. |
| 7. Switch off the operating temperature the engine and after about 2 minutes to double-check the oil level, if necessary to achieve a normal level. |
| 8. Replace the bottom rail of the engine compartment. |
A warning To be able to better observe the operating characteristics of the engine when changing the oil, use of one type of oil and, if possible, the same brand. It is helpful at every oil change to fix the engine plate indicating the brand and viscosity of the oil.
|
