| 1. Before installing check the position of the engine to TDC for cylinder 1. This means that the labels on the belt pulley of the crankshaft or flywheel, and a cam drive gear must coincide. |
| 4-cylinder engine |
 | 2. In the opening of the distributor of ignition set landing neck oil pump shaft parallel to the propeller shaft (longitudinal axis of the motor). |
 | 3. Set the slider to the distributor so that the mark on it coincides with the mark on the edge of the timing case. At the same time the dust cap should be removed. |
| 4. To establish the ignition distributor into position and secure. |
| 5-cylinder engine |
| 5. Remove the Rotor, distributor, remove the dust cap and then set the slider. Light rolling from side to side to check the reliability of mounting the slider. |
| 6. Push the ignition distributor, to close paddle lock, after checking cover for cracks and replace if necessary. |
| 7. If you disconnected, then connect the high voltage to the distributor cap. |
| 8. Adjust the ignition timing. |
The position of the crankshaft of the engine if the check valve is not changed. 
