 printable version
Removing and installing panels finish touring racks
Installation Details panel trim A-pillar (for example, models of manufacture 31/8/98)
| - Details panel installation finishes pillar shown in the illustration, which includes all the links in the text.
- Separate the door seal (2) in the vicinity of the rack A.
- On models of release on 08/31/98, remove the plug (3) and remove the mounting screws (4) in the bottom of the panel is attached to the dashboard through the locks.
- On models of release since 1.9.98 release the upper and lower mounting tabs finishing panel (1).
- Remove the cover (1).
- Installation is in the reverse order - track reliability snaps into place.
 | When you install a new version of the panel on the model of manufacture 08.31.98 lightly expand the screw holes in the rack for installation in their fixer-upper. |
|
|
Racks In Installation Details panel trim B-pillar
| - Installation Details panel trim B-pillar shown in the illustration, which includes all the links in the text.
- Remove the cover threshold corresponding door (see. Section Removal and installation of overlays of the door sill).
- Separate door seals on both sides of the rack B.
- Remove the anchor bolt (1) a seat belt.
- Remove the screws (2) and remove the bottom panel (3) finishing stand.
- On models of release since 1.9.01 to remove the nameplate marked SRS and turn the screw located underneath.
- Remove the screws (4) and release the tab, remove the upper section (5) finishing stand.
- Installation is in the reverse order - track correctness of placing control of the upper anchor assembly belt (6) in the receptacle finishing panel (5). Make sure it snaps into place to secure.
|
|
C-pillar Details of installation of C-pillar trim panel  | | |
| - Details of installation of C-pillar trim panel shown in the illustration, which includes all the links in the text.
- At a corresponding complete set remove additional third seat row.
- Remove the safety net
- On the ML 55 AMG, remove the cover for the storage of a spare wheel.
- Remove the rear roof panel - with the appropriate equipment is not unscrew the screw anchor seat belt seat of the third row.
- Remove the cover threshold in the luggage compartment of the vehicle.
- Fold down the rear seat.
- On models with the VIN A145273, H708319 remove the nameplate marked SRS and turn the screw located underneath.
- Remove the screw (1) and remove the spacer sleeve (3) the anchor node (2) rear seat belt.
- Remove the panel (8), the brackets (4).
- Open and remove the cover (5).
- Remove the screws (6 and 7), release the clamps and remove the upper finishing panel (8) by releasing the tape from her belt.
- At service of the right post, remove the onboard power socket.
- Installation is in the reverse order - track reliability snaps into place.
|
|
|
