 printable version
Setting up the base camshaft
Checking the base camshaft engine series 612  | |
| - Illustrative material to verify the basic camshaft engine 612 is shown in a series of illustrations, which includes all the links in the text.
- Remove the injectors (Y76) (see chap. Power supply system and exhaust).
- Remove the cylinder head cover.
- Provernuv the crankshaft in the normal direction, bring the piston of the first cylinder to TDC - label of a camshaft and its bearing cap should be aligned.
- Block camshafts with special rod (3) inserted through a hole in the lid of the first bearing shaft and charged into the hole (A) into the pinion (2) of the inlet camshaft.
- With the correct basic setting mark (B) gears camshafts (1 and 2) should be aligned. Furthermore, it should occur alignment marks printed on the body and lid of the shaft bearings (arrows).
- If necessary, remove the camshafts (see. Section Removal and installation of components of SRM) and set them into place, ensuring proper alignment marks.
- Deytsvuya in the reverse order of disassembly, replace the components acting in film.
|
|
M628 Setting up the base camshaft engine series 628
| - Illustrative material for adjusting the base camshaft engine 628 is shown in a series of illustrations, which includes all the links in the text.
- Remove the cylinder head cover.
- Provernuv the crankshaft in the normal direction, bring the piston of the first cylinder to TDC.
- Check the basic position of the camshafts - gear to be deployed marks (B) to each other, moreover, must occur combination of labels printed on the body and lid of the shaft bearings (arrows).
- If necessary, make appropriate adjustment.
- Deytsvuya in the reverse order of disassembly, replace the components acting in film.
|
|
|
