REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
			Check the compression pressure in the cylinders
			Checking the engine by means of the vacuum gauge
			Replace accessory drive belt and its tension elements of the mechanism
			Petrol models
			Diesel models
				Removing and installing engine
				Removal and installation of covers of timing
				Replacing the gas distribution chain
				Removal and installation of components of timing
				Setting up the base camshaft
				Checking the reference position of the balancing shaft (only engines Series 628)
				Removal and installation of components of timing
				Removal and installation of a head (s) of cylinders
				Removal and installation of the motor off the inlet port (612 series engine)
				Removing and installing exhaust manifold
				Replacement of a forward epiploon of a cranked shaft
				Removing and installing rear end cover, replace the crankshaft rear oil seal
				Removing and installing vibration damper / belt pulley
				Removal and installation of a flywheel / drive disc
				Removal and installation of supports of the suspension of the power unit
				Service lubrication systems
		System of cooling, heating and air conditioner
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric

printable version

Removal and installation of a flywheel / drive disc

The procedure is similar to the procedure described above for the series 111 motor (see. Section Removal and installation of a flywheel / drive disc).

M628

Details on the installation disk drive motor Series 628

1 - Disk Drive
3 - Disc
4 - The guide pin
5 - Crankshaft
6 - Lock

PERFORMANCE ORDER
Details on the installation disk drive 628 series engines are shown in the illustration, which includes all the links in the text.
The procedure is similar to the procedure described above for the series of engines 112 and 113 (see. Section Removal and installation of a flywheel / drive disc).

« previos page
Removing and installing vibration damper / belt pulley

next page »
Removal and installation of supports of the suspension of the power unit