 printable version
Removing and installing bonnet
 | All self-locking fasteners be replaced without fail! |
In addition 463,333 models Details of installation of the bonnet (except models 463.333)
| - Remove the front grille (see. Section Removal and installation of the front grille).
- Remove the bolts (1) at the top cross beam front end (2), - the beam tilt slightly backwards to ensure better access to nuts with its lower side.
- Disconnect from the beam (2) ground bus.
- Releasing the cable lock is released, the actuator latch lock (5), remove the beam (2).
- Loosen the adjusting screw (6) and pull, disconnect the cable (5) from the castle assembly (4).
- Loosen the screws (3) and remove the lock (4).
- Installation is in the reverse order, if necessary, replace the washers. Make sure that the threaded nipple (7) Cable (5) provides the minimum free lift the hood.
|
|
Models 463,333 Details of installation of the bonnet (model 463.333)
| - Remove the front grille (see. Section Removal and installation of the front grille).
- Remove the bolts (5) in the upper transverse beam front end (6) and remove the last, releasing a cable from the retainer.
- Remove the bolts (1) - if necessary, prepare a replacement washer.
- Disconnect the drive cable (2) and remove the lock assembly (3).
- Installation is in the reverse order - make sure that the arrow mark on the castle assembly has been rotated to the left. The cable connect to the castle only after the installation of the latter.
|
|
|
