 printable version
Removal and installation drive a cable release latch bonnet
Details of the installation of a cable drive release latch bonnet (1 of 2) Details of the installation of a cable drive release latch bonnet (2 of 2)
| - Open the hood and remove assemblage of his castle (see. Section Removal and installation of the bonnet).
- Locate the drive cable (3) on the mudguard wing.
- Remove the cover to the left under the instrument panel (see. Section Removal and installation of the instrument panel of the lower lids), - no disconnects the electrical connector.
- In the passenger compartment, remove the screw (2) and remove the lever (1) release the hood latch lock, pulling him back, while pressing down.
- Pulling back, retract the cable (3) complete with a lever (1) in the interior, - pre-lubricate the rubber grommet in the bulkhead of the engine compartment.
- Disconnect a cable (3) from the lever (1).
- Installation is in the reverse order - damaged grommets in the bulkhead should be replaced.
|
|
|
