 printable version
Removing and installing interior door trim assemblies
The front doors For example, the driver's door Details of installation of panels of an internal upholstery of a forward door (1 of 2) Details of installation of panels of an internal upholstery of the front door (2 of 2)
| - Remove the inside door handle (see. Section Removal and installation of internal door handles).
- 3 On models 463.246 / 249, unscrew the locking lever (A).
- Remove the plug (2) and remove the screws (7) securing the door handle (3).
- Using a suitable wedge separate upholstery panel (1) from the door frame at the location of catches (8) Assess the latches released, replace broken items.
- Disconnect the electrical connector (10) of switches control the operation of electric windows (S21 / 1) and seat (S91).
- Assess the insulating film lining, if necessary, replace the latter.
|
|
Rear doors For example, models with a wheelbase of 2850 mm Details of installation of panels of an internal upholstery of a back door (1 of 3)
Details of installation of panels of an internal upholstery of a back door (2 of 3) Details of installation of panels of an internal upholstery of a back door (3 of 3) The procedure is similar to the procedure described above for the front door. Do not forget to fix the wiring assembly control module (N69 / 3 or N69 / 4) strapping (A). Tailgate Details of installation of the trim panel of the tailgate Arrangement of upholstery clips mounting panel
| - On models corresponding complete set remove the screws (1) securing the bottom section (4) upholstery panel.
- Remove the cap and remove the screws (8) securing the door handle (2).
- Gently squeeze the trim in the direction of the lock, remove the cover (3) of the inner door handle.
- Hooking a wedge in the locations of clamps (arrows), separate upholstery panel (4) from the door frame, Utopia button (5) the single lock, and then post the panel up and remove the final.
- Release the central fastening clips of the top section (6) upholstery panel.
- Remove the left and right finishing pane (7).
- Assess the insulating film lining, if necessary, replace the latter.
- Installation is in the reverse order - damaged during release locks must be replaced without fail.
|
|
| 
