REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
		System of cooling, heating and air conditioner
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
			Outdoor equipment and body parts
				Removing and installing wiper arms
				Removing the drive front wipers
				Removing and installing retractable telescopic nozzle headlight wipers
				Removal, installation and adjustment of the hood
				Replace the bonnet hinge
				Removal and installation of the emblem Mercedes
				Removal, installation and maintenance of components bonnet
				Removal and installation of a gas-filled stop fixing the hood in the open position
				Removal and installation of washer fluid reservoir
				Removing and installing front bumper
				Removing and installing the front upper crossmember frame
				Removing and installing panels to protect the lower engine compartment
				Removing and installing rear bumper
				Removal and installation of the external spare wheel (at a corresponding complete set)
				Removing and installing lockers protect wheel arches
				Removal and installation of doors
				Removal and installation of limiters opening side doors
				Removing and installing tailgate hinges
				Removal and installation of a gas-filled tailgate sliding stop
				Removing and installing exterior door handles
				Removal and installation of panels of an internal upholstery of door assemblies
				Removing and installing door locks
				Removing and installing door mirrors
			Salon Equipment
		Onboard electric

printable version

Removing and installing the front upper crossmember frame

Details of installation of the upper front cross beam frame

PERFORMANCE ORDER
Details of installation of the upper front cross beam of the frame shown in the illustration, which includes all the links in the text.
Remove the lens unit (E1 and E2) (see chap. Onboard electric equipment).
Remove the mounting screws (2), turn over the top of the front cross member of the frame (1) and release of the latches on the rear side of the drive cable (3) release the hood latch bolt (4).
Remove the beam.
Installation is in the reverse order.

« previos page
Removing and installing front bumper

next page »
Removing and installing panels to protect the lower engine compartment