Adjusting the door

1. Check clearances doors with elements of the body. They must be uniform over the entire contour fit. The door must be in the same plane as the wing or not be deeper than 1 mm.
2. Check the clearance back door. The door should match the contour of the rear wing and a lower sidewall or not be deeper than 1 mm.

1. Fully lower the window and open the door.

2. Remove the bolts (1) and remove the retainer.

3. Slightly loosen the fastening bolts (1) door hinge at the bottom and the top.

4. Close the door and displacement hinge adjust the gap.
5. Secure the hinge screws torque 32nm.
6. Secure the clamp, without tightening it.
7. Close the door and adjust the latch, moving it.
8. Attach the clamp bolt torque 28nm.