Removing and installing bonnet

1. Open the hood and set it upright.
2. Remove the front spoiler grille, refer to the appropriate section.
3. Disconnect the connector of the jet washer heater and remove the hoses from the jet as described in Section Removal and installation of the jet washer windscreen.
4. If the solar sensor, disunite its connector located under the ventilation grille.
5. Disconnect the wires from the holder on the hood.
6. In order to facilitate subsequent installation of the hood, mark the position of his felt-tip pen loops.

To release the gas pressure will go ask an assistant to hold the hood. Otherwise, the hood will fall because It can not be kept single lug.

7. Remove gas-filled focus on the ball joint on the hood and remove. For this little screwdriver pry the retaining ring lock (arrow in the illustration). Second abutment remove similarly.

8. Remove the bolts (arrows on an illustration) and remove the hood with the help of the assistant. Before loosening screws loops put a rag between the bonnet and the body to protect against damage to the paintwork.

9. Put the hood on reliable liner.

1. Place the hood in place with the help of an assistant, and secure with screws, without tightening them.
2. Close the hood and check the clearance around the perimeter of fit, adjust if necessary.
3. Tighten the screws fastening torque 8 nm.
4. Install one gas-filled emphasis on ball bearings and insert the retaining ring. Likewise, set the second stop.