Removing and installing the rear of the wing locker

1. Mark a paint position relative to the hub of the rear wheel. This allows the assembly to establish balance the wheel in its former position. Loosen the wheel bolts before jacking the car. Lift the rear of the car, put it on supports and remove the rear wheel.

Operation lifting and car installation on supports is connected with danger! Therefore, prior to the operation to check out the Poddomkrachivanie and towing Introduction to management.

2. Remove the plastic nuts and remove the clip expander (the arrow in the illustration).

3. Remove the wing locker of the wheel arches.

1. Installation is performed in reverse order of removal.
2. Replace the rear wheel so that coincided marks put at removal. Preliminary grease with a thin layer of bearing grease centering the belt drive wheel on the hub. Bolts do not grease the wheels. Rusty bolts replace. Tighten the screws. Lower the car on wheels and tighten bolts cross-wise the moment of 110 nm.