Removing and installing rear window wiper arm

1. Moisten the rear glass of water.
2. Run a short time and stop on the wiper switch. Thus cleaner comes to the end position.
3. Mark the position of the brush when properly adjusted the lever on the glass, such as duct tape.

4. Pull the cap (1) and unscrew the nut (2).

5. Pull the lever (3) and remove it.

It does not damage the nozzles inserted in the axis of the cleaner.

1. Make sure that the wiper motor is in an extreme position. If necessary, run the motor for a short time and stop switch.
2. Install the wiper arm on the axle and set the mark, applied with adhesive tape during removal.
3. Screw the nut (2).
4. Recheck stop on the levers. To do this, close the hood, glass with water and soak for a short time to start the wiper. Levers must return to the set position, and should not go beyond the glass when cleaning glass.
5. If necessary, loosen the nut again and repeat the adjustment.
6. Secure nut (2) 12 nm torque and push the cap.