1. Mark a paint position of a corresponding forward wheel concerning a nave. This allows the assembly to establish balance the wheel in its former position. Loosen the wheel bolts before jacking the car. Lift the front of the car, put it on supports and remove the front wheel.  | Operation lifting and car installation on supports is connected with danger! Therefore, prior to the operation to check out the Poddomkrachivanie and towing Introduction to management. |
2. Remove the front wing locker, refer to the appropriate section.
3. Remove the locking bolt between the wing and the bumper, disconnect and remove the bracket, as described in Section Removal and installation of the bumper.
4. Remove the screws and remove the bottom cover of the spacer clip and trim the longitudinal beam near the wing.
5. Remove the plastic wedge using the front door of the bar holder and remove the clamp.  | 6. Enter the plastic wedge into the gap between the wing (1) and facing the longitudinal beam (2) and remove the lining of the two holders of the clips (arrow in the illustration). |
7. Remove the two nuts (3) securing the wing.
8. Open the hood and set it upright.  | 9. Remove the screws (1) and remove the wing (2). |
10. Remove the cover (3) and sealing tape (4). | 
