REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
			All-wheel drive - general information
			Transfer case
				Changing the oil in the transfer case
				Removing and installing transfer case control module
				Removal and installation of the vacuum receiver control differential lock
				Removal and installation of the vacuum pump drive locking differentials
				Removal and installation of the servo transfer case
				Detaching and attaching the drive shafts to the transfer box
				Removing and installing transfer case
				Removal and installation of supports of suspension transfer case
				The design of the transfer case
				Replacement seals
				Removal and installation of the executive cylinder drive locking center differential
				Removing and Replacing the Front Cover
				Removal and installation of the bearing cover intermediate flange
				Disassembly and assembly of the bearing cap
				Removing and installing the cover intermediate flange
				Removal and installation of an intermediate flange
				Removal and installation of a center differential
				Disassembly and assembly of the center differential
				Removing and installing input and intermediate shafts
				Dismantling the input (drive shaft)
				Dismantling the intermediate shaft
				Removal and installation of components of the mechanism lock the center differential
				Removal and installation of components of the mechanism of switching modes of transfer case
			Bridges
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

printable version

Disassembly and assembly of the bearing cap

Dismantling the bearing cap


1.2 - Maslootboyniki 3 - Drive shaft 4 - Retaining Ring 5 - Ball Bearing 6 - Spacer	7 - Bearing cover 8 - Seal 9 - Connection flange 10 - Thrust Washer

PERFORMANCE ORDER

Remove the transfer case (see. Section Removal and installation of a distributing box).
Remove connecting flange (9) to connect the PTO drive shaft of the rear axle.
Remove the cover (7) of the bearing intermediate flange (see. Section Removal and installation of the bearing cover intermediate flange).
Remove the cover (5) bearing (7).
Replace planted in the gland (8) (see. Section Replacing seals).

« previos page
Removal and installation of the bearing cover intermediate flange

next page »
Removing and installing the cover intermediate flange