REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
			All-wheel drive - general information
			Transfer case
				Changing the oil in the transfer case
				Removing and installing transfer case control module
				Removal and installation of the vacuum receiver control differential lock
				Removal and installation of the vacuum pump drive locking differentials
				Removal and installation of the servo transfer case
				Detaching and attaching the drive shafts to the transfer box
				Removing and installing transfer case
				Removal and installation of supports of suspension transfer case
				The design of the transfer case
				Replacement seals
				Removal and installation of the executive cylinder drive locking center differential
				Removing and Replacing the Front Cover
				Removal and installation of the bearing cover intermediate flange
				Disassembly and assembly of the bearing cap
				Removing and installing the cover intermediate flange
				Removal and installation of an intermediate flange
				Removal and installation of a center differential
				Disassembly and assembly of the center differential
				Removing and installing input and intermediate shafts
				Dismantling the input (drive shaft)
				Dismantling the intermediate shaft
				Removal and installation of components of the mechanism lock the center differential
				Removal and installation of components of the mechanism of switching modes of transfer case
			Bridges
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

printable version

Removal and installation of the servo transfer case

Details of the installation of the executive motor transfer case

1 - Connector
2, 3 - Bolts
4 - Earthing
5 - Transfer Case
M46 / 2 - Executive Engine

PERFORMANCE ORDER
Disconnect the actuator motor assembly (M46 / 2) wiring harness (1).
Remove the bolts (2 and 3) and remove the servo motor (M46 / 2) from the transfer case (5).
Installation is in the reverse order - make sure that the ground bus (4) was not tight and fixing bolts (2 and 3) - are tightened with demanded effort.
Finally, initialize the servo using the reader STAR DIGNOSIS, - ask for help from experts firm HUNDRED Mercedes-Benz.

« previos page
Removal and installation of the vacuum pump drive locking differentials

next page »
Detaching and attaching the drive shafts to the transfer box